I'm not one to complain or gripe over things. Nor am I worried. But it seems the the screw down crown on the BB Pro comes unscrewed slightly. I have a 58 and have never had the issue. But it seems of after a few weeks of wear I get about a half turn that I must screw down?. Has this happened to anyone. Do yall think it matters.
Welcome to my WatchCrunch profile.
Had mine for a month or so. Haven’t had that issue but I’ll keep checking it just in case.
Hello, I've had mine for about two months now. No issues with the crown. Maybe have the AD check it out if it continues. Also, not to tell you how to wear it as it's a personal choice, maybe wear it a bit further up the wrist. See if that stops the crown from moving. Though honestly that bit of play on the crown shouldn't cause it to move.
Put some Locktite on it.
Perhaps the o-ring is perished and no longer putting pressure on the crown when it's screwed down.
Wearing it low on the wrist lets the crown rub on the back of your hand which can move side to side and could unscrew it. Looks like its denting in your skin on the picture.
Had it for 7 months now.. no issues
Remember that the BB Pro crown is slightly larger than the 6.5mm BB58 crown. It also has knurling closer to a Rolex than the BB58 coin edge. Both of these factors might make a difference when wearing low on the wrist.
Not an issue for me. Maybe you should have it checked.
I would try to where is closer to the knuckle on your wrist. Wearing it so close to your hand can rub on the crown. Maybe that will help you but Im not totally sure.