Watch Case Design
I'd like to share the sketch of my case design. I believe it's improving and beginning to demonstrate some noticeable progress.
4 comments
Sort by
Misha
My customizations were prohibited by a major watch company. Currently, I am developing a watch series under my own brand.
Member since
Last active: 1 month ago
the drawing is very good - is it on paper or digital ?
You do need to work on your orthographic drawing skills. The bezel and lug surfaces don’t align on the two views, which will change the proportions of the case in one or other of them. Also, the case shown in the isometric(ish) view bears no relation to the other projections.
As a consequence your design couldn’t be realised in 3D.
I'm not sure what is being conveyed in the lug crotch there. It appears that the area between the convex bevel and convex lugs is filled with some level flat at a lower level?
I'm not sure how the sharp internal angle on the bottom where the lugs starts arching downward is to be machined. Lugs look pointy at insides, but I guess that is expected to be filled by band.
The radii transitioning to the parallel outer lugs and the bezel diameter should probably be wider unless this is not meant to be a fluid curve.
Better than I could do, and fairly distinctive.
the drawing is very good - is it on paper or digital ?
Paper