Rockjunkie
Tai
Rockjunkie
Tai
Recent posts
Recent Comments
The first impression of Vanuatu was; it meant some serious business! Simple, but no nonsense design with a whiff of Sinn U1 and, to a lesser degree, Tudor Pelagos. Maybe the most manly looking diver I have tried so far, and I have tried a few… This contrasts with curvier, bulkier and somewhat exaggerated “in-your-face” look of Khuraburi (which btw is also a looker). The funny thing is, I did not realize that I had signed up for Vanuatu a while back. I was honestly waiting an email for Khuraburi. Naturally, I was a bit surprised when I received two emails within one week. I’m glad I decided to purchase both. Thanks for checking in. 😉
This is my SND253 (black version). My wife got me this one on Valentines Day of 2005. I wore this watch everyday for 12 years. Other than the tiny crown (which is almost impossible to screw down), I really enjoyed wearing the watch. Unfortunately, a watch shop in downtown Boston messed up the rubber gasket during battery replacement which lead to a water damage. It still runs like a champ, but sadly, chrono function was compromised. I still keep this in my watch box alongside my grandfather’s watch. This watch will always be special to me.

My first bund strap after watching an episode on JOMW. This one by Detroit Mint is homaging Citizen Bullhead that was worn by Brad Pitt in Once upon a time in America. The watch is my go-to casual-Friday piece. A great conversation starter mainly due to the bund strap (among other things…).
The semi-bund on Seiko chrono is the one that I made a few moths ago when I picked up leather crafting. It really transformed a $90 quartz watch into something else.
My experience with the bund strap so far is: it works best on tool watches. Also, depending on the profile and leather/hardware used, it can go very well with vintage time pieces or field watches. However, due to the width of the strap, pairing it with mechanical hand-wind watches may be somewhat inconvenient in operating the crown.


A valid question indeed. Think I can provide you with a glimps what to expect from SBTR026 bracelet (from my experience). I have recently purchased SND367 from Japan. Although the initial purpose of the order was to extract the movement (7T92) to swap it with my other broken watch, I decided to keep it as it was. However, the bracelet was a different story… It really re-defined the term “basic”. It is one of the most generic entry-level 20mm bracelet that Seiko uses for sub-$200 watches. Hollowed end links, fold-over mid links and basic stamped clasp. I replaced it with a decent leather strap and I almost forget that this was meant to be a parts watch.


To answer your question (to the best of my knowledge), you maybe able to swap the bracelets, mainly due to the comparable case diameters (40-41mm) and lug width. However, there’s a good chance that the SBTR lugs are not curved. Most likely to be straight and flat. I have yet to own a SARX, but according to what I have seen online, they look curved. One more thing to consider: the drilled spring bar hole positions. They can be near or far from the case, and high or low inside the lugs. Ironically, this is where the hollowed end links are much easier to install compared to the solid ones. I guess there is some wiggle room…
Never was my intention sound like a “know-it-all” (bc I’m not), but hope this helps. Good luck!
Yes, I was quite impressed with the watch. If you can get pass the dial and the case shape that are borrowed from Khaki, there really isn’t anything to nitpick. The finishes and the build quality is outstanding. Especially, the domed sapphire crystal… Just beautiful to look at. I strongly recommend!
