Sharp edges

It all started two years ago. Until then, I always owned two watches at the same time. An everyday metal quartz watch, which for the last 15 years has been a Mondaine, and a plastic Swatch for sports, which never survived more than a few years. After yet another swatch stopped working, I finally decided to buy a G-Shock. The model I chose was the GA-B2100. Somehow, I learned that this watch is nicknamed CasiOak, based on its resemblance to the "Royal Oak". 

What is a "Royal Oak" I asked, and two years later I'm the proud owner of two (until now...) mechanical watches and read daily watch news... I first bought a Baltic Aquascaphe Dual-Crown, and later, although it has some dial design similarities, also a bronze Glycine Combat 39mm. As I could not try them on at any local watch seller, I bought them online. 

Now, just to clarify, I really like both these watches. The Baltic is more of a "dress diver", especially on the flat link bracelet, while the Glycine reminds me of the original James Bond Submariner without being a complete homage. However, both watches also have some really sharp edges. Not only sharp-looking, but also sharp-feeling. In comparison, the Mondaine does not have a single sharp edge; everything is rounded off, with a finishing very similar to my Swiss Army knife.

The Glycine, which came on a Nato, is not really a problem, only when holding it for winding, the underside-edges feels too sharp. However, the flat link bracelet of the Baltic is really much less comfortable than the "fake 5-link" bracelet of the Mondaine. Its underside is very sharp, and because of its lack of comfort, I mostly wear the Baltic on a perlon strap, which is a shame because the bracelet actually looks good!

My question is, are sharp edges a lack of finishing, or are they even a deliberate design choice?

·

Even being on the "affordable end", these watches cost more than 20 Swiss Army knifes, which have over 10 pieces to finish. Granted, many have easier forms than watch cases (not the can opener, however), and Victorinox probably produced enough pieces to afford dedicated finishing machines. Still, I doubt any Victorinox watch has unwanted sharp edges...

Maybe it is more a question of looks? Sharp edges may look more appealing than rounded edges, and rounding off the edges just enough to be comfortable is more challenging? Affordable watch brands would have to choose between rounding off too much or too little.

To me, Baltic is very much a "looks first" watch brand, with its many different surface treatments, so it would make sense to make sure all edges look sharp, while Mondaine might focus more on comfort, even if it means looking less sharp?

How are other watches below 1000€ finished, especially the big brands such as Seiko, Citizen or Orient? I know a lot of people with Tissot watches and had one myself, and although the modules of the T-Touch-watches fail all the time, the finishing always felt very good.