bridgewatches
Eric Wilson
bridgewatches
Eric Wilson
Recent posts
Recent Comments
It’s only my second, so still very much a novice to pocket watches. 😁
The dial is very nice on this one. One tiny hairline from the subdial to the 7 o’clock position.
They suggested sending it to an EDM shop, but it was going to be far more expensive than what I was willing to pay.
In the end, the local shop parted it on their lathe. The blanks end up warping a bit into sort of a bowl shape (see attached images).
From there, I heat them with a torch to anneal them and then flatten them with a mallet and steel bench block. After that, lots of sanding, some additional heat treating to emphasize the layers, some work with a fiber laser to cut the center hole and holes for the posts of the indices, and then sealing.
To be clear, I did not forge the Mokume Gane myself. I bought a rod of it, from a blacksmith in North Carolina, and then got a local machine shop to slice the rod as thin as they could (about 0.7mm thick). I did everything after that. Post process heat treating, sanding, cutting the center hole and holes for the indices, etc.
I wish I could do all the other stuff too, but that involves even more equipment that I don’t have. 😂
Yes, I removed the bezel. It is surprisingly difficult on Arnies. I ended up using a Horotec MSA 07.117 bezel removal tool, and it worked like a charm.
An alternative option would be to stack razor blades until the bezel gap is enough to wedge a case knife in. In other words, take one razor blade and press, or slightly hammer, it into the bezel gap. Then take another, place it on top of the first razor blade and press it into the gap.
Just be very careful not to cut yourself.