Simtime

Simone

0 Posts
1 Followers
0 Following
Follow Following Following
1 year ago
Joined
6.89” / 17.50 cm Wrist

Recent Comments

commented on Regulating 6R35 ·

Based on my recent experience regulating a Seiko SPB143 (cal. 6R35) — and I emphasize that this refers to my specific specimen and not necessarily the entire production class — I’d first mention that when it was new the movement was running about -0.5 s/day, and after a couple of months of regular wear it stabilized at about -6 s/day. Since with ETA/Sellita movements I usually manage to regulate to +0…+2 s/day without too much trouble, I decided to proceed with regulation on this 6R35 despite the fact that many would accept the factory spec.

My impression is that the most difficult part in regulating the speed is the extremely immediate reaction of this movement to even minimal adjustments of the spring-tension lever. In my observation this calibre would benefit from a swan-neck regulator because it is very sensitive to tiny changes in lever position (this is my opinion, based on hands-on experience).

Immediately after adjustment, the movement will show a wide oscillation of rate/ampitude and it will take about 20 minutes on a timegrapher to stabilise, so proceed with absolutely minimal adjustments and wait ~20 minutes before assessing the results (practical guidance from bench work).

In my case, the difference between horizontal versus vertical positions is not vast — within about +8 to +10 seconds/day at most — but that will depend on the individual movement, assembly tolerances and setup. Unlike many ETA/Sellita calibres I have regulated, the beat error on this 6R35 tends to vary by about 0.2 ms between positions, which I found somewhat unusual compared to my experience (this is an observed fact for this exemplar, not necessarily for all).

As always, in the event you need to correct the beat error, do that first, because its effect on speed is significant — a well-known principle in watch servicing. Once properly regulated, my watch has kept a consistent +0.5 s/day for ten months so far, worn almost every day — which is very good for this unit and demonstrates the pay-off of a careful approach.

In short: yes, this 6R35 can be regulated to excellent standards, but one specimen is not representative of the entire class. Others may behave differently. My experience suggests you must enter the job with patience, minimal incremental changes, and strong verification.