You cant regulated in only flat position you have to regulated it in the position that it will be worn that depends on your wrist which side you wear it on and its resting position the NH35 can be regulated very precisely it just takes time because when you adjust the beat error lever and the hair spring anchor lever you are going to have to move it in very tiny increments because even the slightest move in either direction will throw the timing off by a very large degree so you have to be precise and it takes time you can get a perfect straight line on the timagrapher detection and the watch will still perform differently in another position thats why you bave to test all 5 positions and set an average not just in one position it will deviate also dont forget that hairspring will expand and contract due to tempurature fluctuations the megnetic fields will also affect it if exposed to high megnatism but steel is anti magnetic so megnetism wont affect it too much unless its made from a low grade steel, you can check with a compass and if it is just put it on a electromagnet coil and move in different directions that will break the magnetic field and will not be in one direction and wont be magnetic anymore, but yeah just because it looks perfect in one position wont mean it will stay like that plus metal has a memory if its bent it will stay that way even if you unbend it so just keep thet in mind it takes allot of time to adjust this movement to very accurate degree and it can be very accurate, I recommend adjust it and then move to position that will be when on your wrist then check it to see how accurate it is with the timeagraph then adjust it again to get it so its close to 0 as possible I got it down to +3 seconds per day thats as close as I could come and it will be +3 then as the main spring winds down at night will drop to +1, +2.5 seconds so its very good it keeps very good time but its better to make it run a little faster than slower because its better to be early then late, the NH35 36 is a very very good movement its cheap and its very high quality its in alot of watches from the factory they dont regulate it because it would take too nuch time they are avout +15 -15 when you get then new and if you want to regulate it it will take some time you have to test it for 15 days after you regulate it because it needs time to settle and you need to observe how it behaves in the power cycle when fully wound and flully unwound and normal wound it will have a different effect on the timekeeping and also the position it is in so enjoy the hobby a very good movement can be very accurate just takes time to get it into the sweet spot