Jon
Recent posts
Custom dial for bespoke build
Client wanted a 3D T-Rex dial, there's none around, so make one! Found a dino coin, machined and drilled it, gold plated and aged it. Turned out alrig...
16
8
comments
Recent Comments
I measured a few aftermarket dials as 0.8 to 1.0mm thick, so machined this to 0.8mm at the edge. Being a raised pattern, it is much thicker at the centre, but the centre pinions on the NH35 are quite forgiving and the hands clear as they should.
... and there are sellers on AliExpress who'll make your custom design in to a 3d applied decal - basic indices or as complex as you want - for a price
Hi! Well, I turned this one in the lathe, but there are easier ways! Blank dials are readily available if you fancy painting one?
Badges
