Well… I was trying this straight end link bracelet on this San Martin just to see how it looked and fit. But after it was in place, I realized the tolerances were too tight to angle the end links out from between the lugs. And this type of spring bar doesn’t have any grooves for a spring bar tool to grab on the non-quick release side. 😮
Is there any way to get this off without breaking the spring bars??
This account is verified. WatchCrunch has confirmed that this account is the authentic presence for this person or brand.
A sharp spring bar tool can grab the non quick release end. Kind of like a knife catching the edge of a fingernail. There is a YouTube video on it. I think the Norwegian watch maker?
A sharp spring bar tool can grab the non quick release end. Kind of like a knife catching the edge of a fingernail. There is a YouTube video on it. I think the Norwegian watch maker?
Thanks. I just had a look on YouTube and found a dental floss trick. I’ll try it out and see how that goes.
Okay, the floss trick didn’t work, but after a lot of fiddling around I finally found an angle that allowed it to just barely clear the lugs.